DRILL MONITOR displays important information such as HOLE DEPTH, BIT DEPTH, and DRILLING RATE on a LARGE and easy to read LCD display. Also displayed is the BOOM ANGLE, front to back and side to side. Make setup a breeze when drilling pre-split holes or whenever the angle really count. No more guessing! Simply read the LCD screen to determine your boom angle when setting up each hole. Displayed on the LCD are the angle of the boom shown in one of two selectable methods.
- Angle shown in degrees. 0 - 60 degrees
- Slope of boom referenced to 1 foot.
The HOLE Depth readout displays the exact depth of the hole to the nearest tenth of an inch. Know exactly how deep your hole is, NO more over or under drilling holes. Bit Depth readout lets you know exactly where your bit is in reference to the bottom of the hole. Also know exactly where a seam is to aid in loading holes.
Large easy to read LCD is also Back lit making it easy to read even in the worst of conditions. Power is drawn from the rigs battery. The Drill Monitor draws no power when it’s power switch is turned off, eliminating any chance of draining the battery. Yet, even with no power supplied, the Drill Monitor retains all pertinent information such as total hole footage drilled.
Also included on the same screen is the drill rate. Know how many feet/minute or feet/hour you are drilling. Knowing your drill rate can immediately show a loss of production due to dull bits or other causes. Use the Drill Monitor to optimize your drill rate by adjusting feed pressure or rotation speeds and see the results immediately.
Power supply: 12 Volts DC To 30 Volts DC
LCD: 4 line x 20 character Large 8 mm high lettering - Back lit
-20 C to +70 C
-4 F to +158 F
ON: 1.0 Amp
OFF: 0.0 Amp
Length 8.5 in (21.6 cm)
Width 6.0 In (15.2 cm)
Depth 3.0 In (7.6 cm)
Total Angle Range: +/- 60 deg
Linear Range: +/- 45 deg
Threshold and resolution: .001 deg
Linearity: +/- .25 deg
Null to 10 deg: +/-.1 deg
10 deg to 45deg: +/- 1% angle